Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION; 2013 MY FR-S [03/2012 -]

HINT
* The procedures listed below are for the LH side.
* Use the same procedures for the RH and LH sides.

1. INSTALL REAR SPEED SENSOR LH

(a) Install the rear speed sensor LH with the 3 bolts.

Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

NOTICE:
Prevent foreign matter from attaching to the rear speed sensor LH tip, installation surface and sensor body.

(b) Connect the 2 harness clamps.

NOTICE:
Do not twist the wire harness for the rear speed sensor LH when installing it.

(c) Pull the rear speed sensor LH grommet out from vehicle interior.

NOTICE:
* Do not pull the rear speed sensor LH wire harness.
* Do not fix the pass-through grommet at an angle.

(d) Connect the rear speed sensor LH connector.

(e) Install the luggage compartment floor mat.

2. INSTALL REAR WHEEL LH

Torque : 120 Nm (1224 kgf-cm, 89 ft-lbf)

3. INSPECT SPEED SENSOR SIGNAL

Test Mode Procedure