Cruise SET Indicator Light Circuit

CRUISE CONTROL: CRUISE CONTROL SYSTEM: Cruise SET Indicator Light Circuit; 2013 MY FR-S [03/2012 -]
- Cruise SET Indicator Light Circuit

DESCRIPTION

* The ECM turns on the SET indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.

* The cruise control SET indicator light illuminates when the cruise control system is controlling vehicle speed.

* The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

WIRING DIAGRAM

Refer to Cruise Main Indicator Light Circuit Cruise Main Indicator Light Circuit.

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.

(e) Check the cruise control SET indicator light by performing the Active Test.

Combination Meter





OK:

The cruise control SET indicator light goes on or goes off.

NG -- REPLACE COMBINATION METER ASSEMBLY Removal

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures