Installation

FA20 ENGINE MECHANICAL: DRIVE BELT: INSTALLATION; 2013 MY FR-S [03/2012 -]

1. INSTALL FAN AND GENERATOR V BELT









(a) Set the fan and generator V belt onto every part.

(b) While turning the belt tensioner counterclockwise.

NOTICE:
Make sure that the fan and generator V belt is properly installed to each pulley.

(c) Check that the fan and generator V belt fits properly in the ribbed grooves.

HINT
Make sure to check by hand that the fan and generator V belt have not slipped out of the grooves on the bottom of the pulley.

2. INSTALL BELT GENERATOR COVER

(a) Install the belt generator cover with the 2 blots.

Torque : 6.4 Nm (65 kgf-cm, 57 in-lbf)

(b) Engage the 2 wire harness clamps and install the wire harness to the belt generator cover.

3. INSTALL GENERATOR COVER

(a) Install the generator cover with the 2 blots.

Torque : 6.4 Nm (65 kgf-cm, 57 in-lbf)

4. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

(a) Install the air cleaner cap with air cleaner hose with the 3 blots.

Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

(b) Install the air cleaner cap with air cleaner hose with the 2 hose clamps.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

(c) Connect the No. 2 ventilation hose.

(d) Connect the mass air flow meter connector.

(e) Engage the wire harness clamp and install the wire harness to the air cleaner cap.