Odo/Trip Switch Malfunction

METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: Odo/Trip Switch Malfunction; 2013 MY FR-S [03/2012 -]
- Odo/Trip Switch Malfunction

DESCRIPTION

The ODO/TRIP display of the combination meter changes each time the trip switch is pressed.

HINT
For more information about switching between displays, refer to the owner's manual.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (MULTI DISPLAY SELECT SWITCH, ODO/TRIP CHANGE SW)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Combination Meter / Data List.

(e) According to the display on the tester, read the Data List.

Combination Meter





OK:

The value displayed on the Techstream changes in accordance with the actual ODO/TRIP change switch and multi display select switch operation.

NG -- INSPECT TRIP SWITCH

OK -- REPLACE COMBINATION METER ASSEMBLY Removal

2. INSPECT TRIP SWITCH

(a) Remove the trip switch Removal.









(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE TRIP SWITCH Removal
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (COMBINATION METER - TRIP SWITCH AND BODY GROUND)

(a) Disconnect the D7 combination meter assembly connector.

(b) Disconnect the D64 trip switch connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):





Standard Resistance (Check for Short):





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE COMBINATION METER ASSEMBLY Removal