How to Proceed With Troubleshooting
LIGHTING (EXT): LIGHTING SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING; 2013 MY FR-S [03/2012 -]
HINT
* Use the following procedure to troubleshoot the lighting system.
* *: Use the Techstream.
1. VEHICLE BROUGHT TO WORKSHOP
NEXT -- Continue to next step.
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK
NEXT -- Continue to next step.
3. INSPECT BATTERY VOLTAGE
(a) Measure the battery voltage with the ignition switch off.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
NEXT -- Continue to next step.
4. CHECK FOR DTC*
(a) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.
Result:
B -- Go to step 7
A -- Continue to next step.
5. PROBLEM SYMPTOMS TABLE
(a) Refer to Problem Symptoms Table Exterior Lighting System.
Result:
B -- Go to step 7
A -- Continue to next step.
6. OVERALL ANALYSIS AND TROUBLESHOOTING*
(a) Data List / Active Test Exterior Lighting System
(b) Terminals of ECU Exterior Lighting System
NEXT -- Continue to next step.
7. ADJUST, REPAIR OR REPLACE
NEXT -- Continue to next step.
8. CONFIRMATION TEST
NEXT -- END