Tire Pressure Warning Light Circuit

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: Tire Pressure Warning Light Circuit; 2013 MY FR-S [03/2012 -]
- Tire Pressure Warning Light Circuit

DESCRIPTION

If the door control receiver detects any problems, the tire pressure warning light blinks (stays on after blinking for 1 minute) and tire pressure monitoring is cancelled at the same time. At this time, the ECU stores a DTC in memory.

Connecting terminals TC and CG of the DLC3 makes the tire pressure warning light blink to output DTCs.

The door control receiver sends the tire pressure warning light illumination request signal to the main body ECU (network gateway ECU) via a direct line. The main body ECU (network gateway ECU) then sends the signal to the combination meter assembly via CAN communication.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When replacing the door control receiver, read the IDs stored in the old ECU using the Techstream and write them down before removal.
* It is necessary to perform registration Programming and Relearning of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.
* When replacing the door control receiver on vehicles, be sure to perform Registration of Recognition Code to register the transmitter IDs after ECU replacement Registration.

PROCEDURE

1. CHECK FOR DTC (CAN COMMUNICATION SYSTEM)

(a) Check if a CAN communication system DTC is output Diagnosis System.

Result:





B -- GO TO CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

2. CHECK DTC OUTPUT (B1247)

(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(b) Turn the ignition switch off.

(c) Turn the ignition switch to ON.

(d) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.

OK:

DTC B1247 is not output.

NG -- GO TO DTC B1247 B1247
OK -- Continue to next step.

3. CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / Combination Meter / Active Test.

(f) Check the condition of the tire pressure warning light by using the Techstream.

Combination Meter





OK:

The tire pressure warning light turns on or off in accordance with the Techstream operation.

NG -- GO TO METER / GAUGE SYSTEM Meter / Gauge System

OK -- REPLACE DOOR CONTROL RECEIVER Removal