Removal
FA20 ENGINE CONTROL: IGNITION COIL AND SPARK PLUG: REMOVAL; 2013 MY FR-S [03/2012 -]
1. SET HOOD SUB-ASSEMBLY Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal
3. REMOVE FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY LH Removal
4. REMOVE FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY RH Removal
5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE Removal
6. DISCONNECT ENGINE WIRE
(a) Disengage the 4 clamps, and disconnect the engine wire.
(b) Disengage the 3 clamps and wire harness clamp bracket mount bolt, and disconnect the engine wire.
(c) Disengage the claw and disconnect the engine wire (for Manual Transmission).
(d) Disengage 2 clamps and disconnect the engine wire.
7. REMOVE EXHAUST MANIFOLD
Removal
8. INSTALL ENGINE HANGER Removal
9. SET SST
(a) Tie the front exhaust pipe sub-assembly onto the front suspension cross member sub-assembly using rope.
HINT
This operation is necessary in order to prevent the front exhaust pipe sub-assembly from falling off.
(b) Remove the 2 nuts.
(c) Install the engine hanger with the bolt. Removal
Torque : 33 Nm (337 kgf-cm, 24 ft-lbf)
(d) Hoist the engine assembly up with an engine sling device and a mini crane.
(e) Install the SST to between the engine mount and front.
SST : 09250-53011
NOTICE:
Make sure not to install SST in a wrong way.
HINT
* LH Side Part No. : 09250-53011L
* RH Side Part No. : 09250-53011R
10. REMOVE INJECTOR COVER (for Bank 2)
(a) Disengage the clamp, and disconnect the fuel hoses.
(b) Remove the 2 bolts and injector cover.
11. REMOVE IGNITION COIL ASSEMBLY (for Bank 2)
(a) Disconnect the 2 ignition coil connectors from the ignition coil assembly.
(b) Remove the 2 bolts and remove the 2 ignition coils.
12. REMOVE SPARK PLUG (for Bank 2)
(a) Using the spark plug wrench 14 mm, tilt extension bar 35 mm and universal joint 54 mm, and remove the 2 spark plugs.
13. REMOVE INJECTOR DRIVER Removal
14. REMOVE IGNITION COIL ASSEMBLY (for Bank 1)
(a) Disconnect the 2 ignition coil connectors from the ignition coil assembly.
(b) Remove the 2 bolts and remove the 2 ignition coils.
15. REMOVE SPARK PLUG (for Bank 1)
(a) Using the spark plug wrench 14 mm, tilt extension bar 35 mm and universal joint 54 mm, and remove the 2 spark plugs.