SRS Warning Light Does Not Come On
SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: SRS Warning Light does not Come ON; 2013 MY FR-S [03/2012 -]
- SRS Warning Light does not Come ON
DESCRIPTION
The SRS warning light is located on the combination meter assembly.
When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned from off to ON, and then goes off automatically.
If there is a malfunction in the SRS, the SRS warning light comes on to inform the driver of a problem.
The SRS is equipped with a voltage-increase circuit (DC-DC converter) in the airbag ECU assembly in case the source voltage drops.
When the battery voltage drops, the voltage-increase circuit (DC-DC converter) functions to increase the voltage of the SRS to normal voltage.
A malfunction in this circuit is not stored in the airbag ECU assembly. The SRS warning light automatically goes off when the source voltage returns to normal.
The signal to illuminate the SRS warning light is transmitted from the airbag ECU assembly to the combination meter assembly through the CAN communication system.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. CHECK BATTERY VOLTAGE
(a) Measure the voltage of the battery.
Standard Voltage:
11 to 14 V
NG -- INSPECT CHARGING SYSTEM AND BATTERY How to Proceed With Troubleshooting
OK -- Continue to next step.
2. CHECK CONNECTOR
(a) Turn the ignition switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the connector is properly connected to the combination meter assembly.
OK:
The connector is properly connected.
HINT
If the connector is not connected securely, reconnect the connector and proceed to the next inspection.
(d) Disconnect the connector from the combination meter assembly.
(e) Check that the terminal of the connector is not damaged.
OK:
The terminal is not deformed or damaged.
NG -- REPAIR OR REPLACE CONNECTOR
OK -- Continue to next step.
3. CHECK WIRE HARNESS (COMBINATION METER ASSEMBLY - BODY GROUND)
(a) Connect the cable to the negative (-) battery terminal.
(b) Turn the ignition switch to ON.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(d) Turn the ignition switch off.
(e) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE WIRE HARNESS
OK -- Continue to next step.
4. CHECK SRS WARNING LIGHT
(a) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(b) Connect the connector to the combination meter assembly.
(c) Disconnect the connector from the airbag ECU assembly.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the ignition switch to ON.
(f) Check the SRS warning light condition.
OK:
After the primary check period, the SRS warning light goes off for approximately 10 seconds and turns back on.
HINT
The primary check period is approximately 6 seconds after the ignition switch is turned to ON.
NG -- REPLACE COMBINATION METER ASSEMBLY Removal
OK -- REPLACE AIRBAG ECU ASSEMBLY Removal