Driver Side Seat Belt Warning Light Does Not Operate

SEAT BELT: SEAT BELT WARNING SYSTEM: Driver Side Seat Belt Warning Light does not Operate; 2013 MY FR-S [03/2012 -]
- Driver Side Seat Belt Warning Light does not Operate

DESCRIPTION

The combination meter assembly illuminates, blinks or turns off the seat belt warning light on the combination meter assembly in accordance with the state of the front seat inner belt assembly LH.

HINT
The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (DRIVER SIDE SEAT BELT WARNING LIGHT)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.

(e) Perform the Active Test according to the display on the Techstream.

OK:

Driver side seat belt warning light condition can be switched by Active Test.

Combination Meter





NG -- REPLACE COMBINATION METER ASSEMBLY Removal
OK -- Continue to next step.

2. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH

(a) Remove the front seat inner belt assembly LH Removal.

(b) Inspect the front seat inner belt assembly LH Front Seat Inner Belt Assembly.

NG -- REPLACE FRONT SEAT INNER BELT ASSEMBLY LH Removal
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT ASSEMBLY LH - COMBINATION METER ASSEMBLY - BODY GROUND)

(a) Disconnect the H19 front seat inner belt assembly LH connector.

(b) Disconnect the D7 combination meter assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE COMBINATION METER ASSEMBLY Removal