Operation CHARM: Car repair manuals for everyone.
Home >> Scion >> 2013 >> FR-S F4-2.0L (FA20) >> Repair and Diagnosis >> Sensors and Switches >> Sensors and Switches - Restraints and Safety Systems >> Impact Sensor >> Service and Repair >> Side Airbag Sensor (For Front Side) >> Installation

Installation






SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR (for Front Side): INSTALLATION; 2013 MY FR-S [03/2012 -]

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL DOOR SIDE AIRBAG SENSOR

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.

(c) Connect the connector to the door side airbag sensor.





NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(1) Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).

(d) Insert the pin (stopper) into the door hole and install the door side airbag sensor to the front door panel with the mew nut.

Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

NOTICE:
* If the door side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the door side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
* Make sure that the pin (stopper) is securely inserted into the body hole.
* Tighten the nut while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.

(e) Check that there is no looseness in the installation parts of the door side airbag sensor.

2. INSTALL FRONT DOOR SERVICE HOLE COVER Front Door Reassembly

3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Front Door Reassembly

4. INSTALL DOOR ARMREST COVER Front Door Reassembly

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

6. PERFORM DIAGNOSTIC SYSTEM CHECK

Reading and Clearing Diagnostic Trouble Codes

7. INSPECT SRS WARNING LIGHT

Diagnosis System
pro multis · About Operation CHARM