Installation

AXLE AND DIFFERENTIAL: REAR AXLE HUB: INSTALLATION; 2013 MY FR-S [03/2012 -]

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH

(a) Install the rear axle hub and bearing assembly to the rear axle assembly with the 4 bolts.

Torque : 65 Nm (663 kgf-cm, 48 ft-lbf)

2. INSTALL REAR DISC Reassembly

3. INSTALL REAR CALIPER ASSEMBLY Reassembly

4. STAKE REAR AXLE SHAFT NUT LH

(a) Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using a non-residue solvent.

NOTICE:
* Be sure to perform this step even when using a new rear drive shaft assembly.
* Keep the threaded parts free of oil and foreign matter.

(b) Install the new rear axle shaft nut.

Torque : 190 Nm (1938 kgf-cm, 140 ft-lbf)

HINT
Stake the rear axle shaft nut LH after inspecting for looseness and runout in the following steps.

5. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub

6. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub

7. STAKE REAR AXLE SHAFT NUT LH

(a) Using a chisel and hammer, stake the rear axle shaft nut LH.





8. INSTALL REAR SPEED SENSOR LH

(a) Install the bolt and the rear speed sensor LH.

Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

9. INSTALL REAR WHEEL

Torque : 120 Nm (1224 kgf-cm, 89 ft-lbf)

10. ADJUST PARKING BRAKE LEVER TRAVEL

Adjustments

11. INSPECT SPEED SENSOR SIGNAL

Test Mode Procedure