Disassembly

TL70 MANUAL TRANSMISSION / TRANSAXLE: INPUT SHAFT: DISASSEMBLY; 2013 MY FR-S [03/2012 -]

1. INSPECT INPUT SHAFT BEARING

(a) Install the input shaft to the output shaft, and then check the input shaft bearing.





Standard:

Abnormal fitting, interfering, abnormal noise, or looseness should not be found.

HINT
If any abnormality is found, replace the input shaft bearing with a new one.

2. INSPECT RADIAL CLEARANCE

(a) Install the input shaft to the output shaft, and then using a dial indicator, measure the radial clearance.





Standard clearance:

0.029 to 0.072 mm (0.00114 to 0.00283 in.)

Maximum clearance:

0.072 mm (0.00283 in.)

HINT
If the clearance exceeds the maximum, replace the input shaft bearing and output shaft with a new ones.

3. INSPECT FRONT INPUT SHAFT BEARING

(a) Check the front input shaft bearing.





Standard:

Abnormal fitting, interfering, abnormal noise, or looseness should not be found.

HINT
If any abnormality is found, replace the front input shaft bearing with a new one.

4. REMOVE INPUT SHAFT BEARING

(a) Remove the input shaft bearing from the input shaft.





5. REMOVE NO. 3 SYNCHRONIZER RING

(a) Remove the No. 3 synchronizer ring from the input shaft.





6. REMOVE FRONT INPUT SHAFT BEARING

(a) Using 2 screwdrivers and a hammer, remove the front bearing shaft snap ring from the input shaft.





NOTICE:
Use a cloth to prevent the front bearing shaft snap ring from popping out.

(b) Using SST and a press, remove the front input shaft bearing from the input shaft.





SST : 09950-00020