Installation

CLUTCH: CLUTCH PEDAL SWITCH: INSTALLATION; 2013 MY FR-S [03/2012 -]

1. INSTALL CLUTCH START SWITCH ASSEMBLY

(a) Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Connect the clutch start switch connector.

(c) With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.









Standard clearance:

3.5 to 4.0 mm (0.138 to 0.157n.)

HINT
Do not turn the clutch start switch assembly.

2. INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY

Installation

3. INSTALL CLUTCH SWITCH ASSEMBLY

(a) Install the clutch switch assembly to the clutch pedal support sub-assembly with the nut.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Connect the clutch switch connector.

(c) Without depressing the clutch pedal, check that there is no clearance between the switch shaft and the clutch pedal stopper.









HINT
Do not turn the clutch switch assembly.

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

5. INSTALL INSTRUMENT SIDE PANEL LH Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation

7. INSPECT CLUTCH START SYSTEM Initial Inspection and Diagnostic Overview