Toe-In

Fig. 4 Front toe-in adjustment:

Ensure tires are properly inflated prior to checking or adjusting toe. CFRONT

The following procedure may be used to correct toe-in, if out of specifications.
1. Loosen both left and right tie rod locknuts, Fig. 4.
2. Turn both tie rods an equal amount until toe-in is within specifications.

Fig. 2 Outer arm mounting bolts:

REAR

The following procedure may be used to correct toe, if out of specifications.
1. Raise and support rear of vehicle, then remove rear wheel and tire assembly.
2. Loosen outer arm mounting bolts, Fig. 2.
3. If toe-in is excessive, tighten outer arm mounting bolts while pushing end of spindle towards rear of vehicle.
4. If toe-out is excessive, tighten outer arm mounting bolts while pulling end of spindle toward front of vehicle.
5. Tighten outer arm attaching mounting bolt.