2. Camber and Caster

2. CAMBER AND CASTER
- Inspection
1) Place front wheel on turning radius gauge. Make sure ground contacting surfaces of front and rear wheels are set at the same height.





2) Set ST into the center of the wheel, and then install the wheel alignment gauge. ST 927380000 ADAPTER

NOTE: Refer to the "SPECIFICATIONS AND SERVICE DATA" for the camber and caster values.

- Front camber adjustment
1) Loosen two self-locking nuts located at lower front portion of strut.

CAUTION:
- When adjusting bolt needs to be loosened or tightened, hold its head with a wrench and turn self-locking nut.
- Discard loosened self-locking nut and replace with a new one.





2) Turn camber adjusting bolt so that camber is set at the specification.

NOTE: Moving the adjusting bolt by one scale graduation changes camber by approximately 0010,.





3) Tighten the two self-locking nuts.

Tightening torque:
152 ± 20 Nm (15.5 ± 2.0 kg-m, 112 ± 14 ft-lb)