Converter Case Section

1. Wrap the axle-shaft serration with vinyl taped
2. Remove the differential side retainer. Hold the differential case assembly by hand to avoid damaging retainer mounting hole of the converter case and speedometer gears.





3. Extract the axle shaft. Do not reuse the circlip.
4. Remove the differential case assembly.
a. Remove the seal pipe if it is attached. (Reusing is not allowed.)
b. Be careful not to damage the retainer mounting hole of the converter case and the speedometer gears.





5. Remove the vehicle speed sensor 2.
a. Pay attention so as not to forget to remove the sensor key and packing from the converter case.





6. Remove the snap ring. Then remove the speedometer driven gear.





7. Tap out the speedometer shaft to the outside of the case, and remove the oil seal.