Front ABS Sensor

FRONT ABS SENSOR
1) Install tone wheel on hub, then install housing on hub assembly.
2) Temporarily install front ABS sensor on housing.

CAUTION: Be careful not to strike ABS sensor's pole piece and tone wheel's teeth against adjacent metal parts during installation.

3) Install front drive shaft to hub spline.





4) Install front ABS sensor on strut and wheel apron bracket.

Tightening torque:
32 ± 10 Nm (3.3 ± 1.0 kg-m, 24+7 ft-lb)

5) Place a thickness gauge between ABS sensor's pole piece and tone wheel's tooth face. After standard clearance is obtained over the entire perimeter, tighten ABS sensor on housing to specified torque.

ABS sensor standard clearance:
0.9 - 1.4 mm (0.035 - 0.055 in)

Tightening torque:
32 ± 10 Nm (3.3 ± 1.0 kg-m, 24+7 ft-lb)

CAUTION: Check the marks on the harness to make sure that no distortion exists. (RH: white, LH: yellow)

NOTE: If the clearance is outside specifications, readjust.