Using A Subaru Select Monitor

CONNECT SELECT MONITOR.
1. Connect Subaru Select Monitor to data link connector.
2. Turn ignition switch and Subaru Select Monitor switch ON.
3. After display is shown, press slash "/" key.
4. After AT mode is displayed, press function "[0]". (Display returns to AT mode when slash "/" is pressed during on-board diagnostics operation.)

READ TROUBLE CODE SHOWN ON DISPLAY.
1. Connect Subaru Select Monitor to data link connector.
2. Designate mode using function key. Press [F] [B] [0] [ENT] in that order.
3. Ensure trouble code(s) is shown.

PREVIOUS TROUBLE CODE READING
1. Connect Subaru Select Monitor to data link connector.
2. Designate mode using function key. Press [F] [B] [1] [ENT] in that order.
3. Ensure displayed trouble code(s).