Inspection With Scan Tool

INSPECTION

1. Turn ignition switch to OFF.
2. Connect scan tool connector to data link connector.
3. Turn scan tool into ABS mode.





4. Press F, 1 and 0 on the scan tool.
5. Read the scan tool display.
CHECK: Is the indicated reading 2.3 ± 0.2 Volts when the vehicle is in horizontal position?
YES: Go to next step 6.
NO: Replace G sensor.

6. Remove console box.
7. Remove G sensor from vehicle. (Do not disconnect connector.)
8. Read the scan tool display.





CHECK: Is the indicated reading 3.9 ± 0.2 Volts when G sensor is inclined forwards to 90�?
YES: Go to next CHECK.
NO: Replace G sensor.





Read the scan tool display.
CHECK: Is the indicated reading 0.7 ± 0.2 Volts when G sensor is inclined backwards to 90�?
YES: G sensor is normal.
NO: Replace G sensor.