Radiator Hose: Service and Repair

REMOVAL
1. Release fuel pressure. Refer to Powertrain Management.





2. Disconnect ground cable from the battery.





3. Drain engine coolant completely.





4. Remove intake manifold. Refer to Engine.





5. Disconnect heater inlet hose.





6. Disconnect radiator inlet hose from water pipe.





7. Remove bolts which install water pipe on cylinder block.

INSTALLATION
1. Install water pipe on cylinder block. Tighten bolts to 6.4 ±0.5 Nm (4.7 ±0.4 ft. lbs.) .

CAUTION: Use a new O-ring.

2. Connect radiator inlet hose.
3. Connect heater inlet hose.
4. Install intake manifold. Refer to Engine.
5. Connect ground cable to battery terminal.