Driver Air Bag Module

REMOVAL AND INSTALLATION

CAUTION:





The airbag module must not be disassembled. The airbag module cannot be used again once inflated.






When removing and installing the airbag module, the operator should stand, as much as possible, on the side of the airbag module.






After removal, the airbag module should be kept away from heat and light sources, and stored on a clean, flat surface to prevent from any damage to its lower structure.


DRIVER'S AIRBAG MODULE
1. Set front wheels in straight ahead position.
2. Turn ignition switch off.
3. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.






4. Using TORX BIT T30, remove two TORX bolts.






5. Disconnect airbag connector on back of airbag module.
6. Refer to "SERVICE PRECAUTIONS" for handling of a removed airbag module.
7. Installation is in the reverse order of removal.

CAUTION: Do not allow harness and connectors to interfere or get caught with other parts.