Removal and Installation

1. Disconnect battery ground cable.





2. Loosen clamp which connects air intake duct to mass air flow sensor.





3. Loosen clamp which connects air intake chamber to throttle body.





4. Disconnect blow-by hose and air hose, and remove air intake chamber and air intake duct as a unit.





5. Disconnect connector from idle air control solenoid valve.





6. Disconnect PCV hose (A) and pressure regulator vacuum hose (B).





7. Disconnect air by-pass hose from idle air control solenoid valve.





8. Remove bolts which install idle air control solenoid valve to throttle body.





9. Disconnect engine coolant hoses from idle air control solenoid valve, and take them off.





10. Installation is in the reverse order of removal.

CAUTION: Replace gasket with a new one.

Tightening torque:
6.4 ± 0.5 Nm (0.65 ± 0.05 kg.m, 4.7 ± 0.4 ft.lb)