Front Wiper and Washer
Removal and Installation1. BLADE
1. Pull out blade following the arrow direction, from arm while pushing up locking clip (A).
2. Install in the reverse order of removal.
2. WIPER ARM
1. Open front hood.
2. Remove cap. Remove the nut which secure wiper arm, and remove wiper arm.
3. Install in the reverse order of removal.
NOTE: Remove metal sludge from the wiper arm fixture before installing it.
Tightening torque: 20 ± 3 N.m (2.0 ± 0.3 kg-m, 14.5 ± 2.2 ft-lb)
3. WIPER MOTOR AND LINK
1. Disconnect ground cable from battery.
2. Detach cowl panel.
NOTE: Apply silicone oil or soap water to both sides of cowl net to facilitate removal.
3. Disconnect electric connector, and remove motor attaching bolts.
4. Remove cowl cover.
5. Remove nut securing motor link on the back side of motor.
6. Remove bolts which secure sleeve unit.
7. Remove wiper link from service hole in front panel.
8. Install in the reverse order of removal.