Cruise Control Command Switch
Cruise Control Command Switch / REMOVAL
WARNING: Before servicing, be sure to read the notes for proper handling of the driver's airbag module.
1. Set front wheels in straight ahead position.
2. Turn ignition switch OFF.
3. Disconnect battery ground cable and wait for at least 20 seconds before starting work.
4. Using TORX(R) BIT T30 (Tamper resistant type), loosen two TORX (R) bolts which secure driver's air-bag module.
5. Disconnect airbag module connector on back of airbag module.
6. Remove horn switch from steering wheel as shown.
7. Disconnect horn and cruise control command switch connector, then remove cruise control command switch.
INSTALLATION
Install is in the reverse order of removal.