Shift Cable: Adjustments

ADJUSTMENT
1. Prior to removal, set select lever to "N" position.
2. Remove rear exhaust pipe and muffler.





3. Remove heat shield cover.





4. Loosen the adjusting nut on each side.





5. Turn adjusting nut B until it lightly touches the connector.





6. While preventing adjusting nut B from moving with a wrench, tighten adjusting nut A.
Tightening torque: 7.5 Nm (0. 76 kgf-cm, 5.5 ft. lbs.)
7. After completion of fitting, make sure the select ever operates smoothly across the entire operating range.
8. Install in the reverse order of removal.