Preparation For Overhaul

Preparation for Overhaul
PROCEDURE
1. Clean oil, grease, dirt and dust from transmission.





2. Remove drain plug to drain oil. After draining, retighten it as before.

NOTE: Do not reuse gasket. Prepare a new gasket.

Tightening torque: 44 Nm (4.5 kgf-cm, 32.5 ft. lbs.)





3. Attach transmission to ST.
ST 499937100 TRANSMISSION STAND SET
4. Rotating parts should be coated with oil prior to assembly.
5. All disassembled parts, if to be reused, should be reinstalled in the original positions and directions.
6. Gaskets, lock washers and lock nut must be replaced with new ones.
7. Liquid gasket should be used where specified to prevent leakage.