Gear Sensor/Switch: Service and Repair
Switches and HarnessREMOVAL
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1) Disconnect the connector battery ground terminal.
2) Remove the air intake duct and cleaner case. (Non-turbo model)
3) Remove the intercooler (Turbo model).
4) Disconnect the connector back-up light switch and neutral position switch.
^ Non-turbo model
^ Turbo model
5) Lift-up the vehicle.
6) Remove the back-up light switch and neutral position switch with harness.
INSTALLATION
BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH
1) Install the back-up light switch and neutral position switch with harness.
Tightening torque: 24.5 Nm (2.5 kgf-m, 18.1 ft. lbs.)
2) Connect the connector of back-up light switch and neutral position switch.
3) Install the air intake duct and cleaner case. (Nonturbo model)
4) Install the intercooler. (Turbo model)
5) Connect the battery ground terminal.