System Specifications

SPECIFICATIONS

















NOTE: STD: Standard I.D.: Inner Diameter O.D.: Outer Diameter OS: Oversize US: Undersize








FRONT EXHAUST PIPE

Camshaft Sprocket bolt 98 Nm (10 kgf-m, 72.4 ft. lbs.)








Camshaft bolts
T1 10 Nm (1.0 kgf-m, 7.2 ft. lbs.)
T2 20 Nm (2.0 kgf-m, 14.5 ft. lbs.)





Cylinder head bolts:
1) Apply a coat of engine oil to washers and bolt threads.
2) Tighten all bolts in sequence to 29 Nm (3.0 kgf-m, 22 ft. lbs.)
3) Retighten all bolts in sequence to 69 Nm (7.0 kgf-m, 51 ft. lbs.)
4) Back off all bolts by 180° first, then back them off a further 180°, in the reverse sequence they were tightened.
5) Tighten all bolts in sequence to 39 Nm (4.0 kgf-m, 29 ft. lbs.)
6) Tighten all bolts in sequence to 80 - 90°
7) Tighten all bolts in sequence a further 40 - 45°

NOTE: Do not tighten bolts for more than 45°.

8) Tighten bolt (A) and (B) a further 40 - 45°.

NOTE: Make sure the sum of retightening angles in previous steps has not exceeded 90°.

Intake Manifold 25 Nm (2.5 kgf-m, 18.1 ft-lb)