Rear
Rear Brake PadREMOVAL
1. Loosen wheel nuts, jack-up vehicle, support it with safety stands, and remove wheel.
2. Remove bottom bolt.
3. Raise caliper body and suspend it securely.
NOTE: Do not disconnect brake hose from caliper body.
4. Remove pad from support.
NOTE: If brake pad is difficult to remove, use the same procedure as for front disc brake pad.
INSTALLATION
1. Apply thin coat of Molykote AS880N (Part No. 26298AC000. to the frictional portion between pad and pad clip.
CAUTION: Do not allow oil or grease to adhere to the sliding surface of pad and disc rotor.
2. Check disc rotor thickness and runout.
3. Install pad on support.
4. Install caliper body on support.
Tightening torque: 39 Nm (4.0 kgf-cm, 28.9 ft. lbs.)
NOTE: If it is difficult to push piston during pad replacement, loosen air bleeder to facilitate work.
5. Depress brake pedal several times.
6. Check that brake fluid level is at max. line.