Front
Front Disc RotorREMOVAL
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Jack-up the vehicle, and then remove the front wheel.
4) Remove the caliper body and support from housing, and suspend it from strut using a wire.
5) Remove the disc rotor.
NOTE: If the disc rotor seizes up within the hub, drive the disc rotor out by installing an 8 mm bolt in holes B on rotor.
6) Clean mud and foreign particles from the caliper body assembly and support.
INSTALLATION
1) Install the disc rotor.
2) Install the caliper body and support to housing.
Tightening torque: 80 Nm (8.2 kgf-m, 59 ft. lbs.)
3) Install the wheel.