Front
Front Disc RotorREMOVAL
1) Set the vehicle on the lift.
2) Loosen the wheel nuts.
3) Jack-up the vehicle, and remove the front wheel.
4) Remove the caliper body from housing, and suspend it from strut using a wire.
5) Remove the disc rotor.
NOTE: If the disc rotor seizes up within the hub, drive the disc rotor out by installing an 8-mm bolt in holes B on the rotor.
6) Clean mud and foreign particles from the caliper body assembly and support.
INSTALLATION
1) Install the disc rotor.
2) Install the caliper body on housing.
15 and 16 inch type:
Tightening torque: 80 Nm (3.2 kgf-m, 59 ft. lbs.)
17 inch type:
Tightening torque: 155 Nm (15.8 kgf-m, 114.3 ft. lbs.)
3) Install the wheel.