Oil Pressure Sender: Service and Repair

Oil Pressure Switch

REMOVAL
1. Remove generator from bracket.





2. Disconnect terminal from oil pressure switch.





3. Remove oil pressure switch.

INSTALLATION





1. Apply fluid gasket to oil pressure switch threads.
Fluid gasket: Part No. 004403042 THREE BOND 1324 or equivalent





2. Install oil pressure switch onto engine block.
Tightening torque: 25 Nm (2.5 kgf-m, 18. 7 ft. lbs.)





3. Connect terminal of oil pressure switch.
4. Install generator on bracket.

INSPECTION
Make sure oil does not leak or seep from where the oil pressure switch is installed.