Rear ABS Sensor

REMOVAL
1. Disconnect the ground cable from battery.





2. Disconnect the connector from rear ABS wheel speed sensor.











3. Remove the sensor harness bracket from rear arm.





4. Remove the rear ABS wheel speed sensor from rear arm.

CAUTION:
^ Be careful not to damage the sensor portion.
^ Do not apply excessive force to the sensor harness.

INSTALLATION
Install in the reverse order of removal.

CAUTION: Be careful not to damage the sensor portion.

Tightening torque:
Sensor: 7.5 Nm (0.76 kgf-m, 5.5 ft. lbs.)
Bracket: 33 Nm (3.3 kgf-m, 24 ft. lbs.)

NOTE: Check the identification (mark) on the harness to make sure that no warp exists. (RH:K5(White), LH:K6(Yellow))

INSPECTION
ABS WHEEL SPEED SENSOR
Refer to ABS wheel speed sensor inspection. Front ABS Sensor