Diagram Information and Instructions

FOREWORD

1. ILLUSTRATION EXAMPLE

- Symbols and number of points indicate the welding method and the number of welding points. Text in brackets indicate the direction of removal for welded parts, and numbers indicate the number of panels to be drilled to remove welded sections of panels.
- Areas enclosed by a broken line indicates work from the opposite side (rear side).
- Always apply anticorrosion wax to the welding locations when replacing panels.






2. REMOVAL DIRECTION

Areas are divided into four groups of inside, outside, top, and bottom, and these directions are defined as shown in the following figure.






3. NUMBER OF PANELS TO BE DRILLED

Depending on the number of panels, drilling is performed through one or two panels, and this is listed together with the removal direction.

1. Drilling through one plate






2. Drilling through two plate






4. HOLE DRILLING FOR PLUG WELDING

1. Drilling of holes for plug welding in service parts






2. Drilling of holes on service parts for plug welding, to match the holes on the vehicle side.






5. MEANING OF SYMBOLS