Brake Pipe
REMOVALNOTE: Airbag system wiring harness is routed near the center brake pipe.
CAUTION:
^ All airbag system wiring harness and connectors are colored yellow. Do not use the electrical test equipment on these circuits.
^ Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
^ When removing the brake pipe, make sure that it is not bent.
INSTALLATION
NOTE: Airbag system wiring harness is routed near the center brake pipe.
CAUTION:
^ All airbag system wiring harness and connectors are colored yellow. Do not use the electrical test equipment on these circuits.
^ Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
^ When installing the brake pipe, make sure that it is not bent.
^ After installing the brake pipe and hose, bleed air.
^ After installing the brake hose, make sure that it does not touch the tire or suspension assembly, etc.
Brake pipe tightening torque: 15 Nm (1.5 kgf-m, 10.8 ft. lbs.)
INSPECTION
Ensure there are no cracks, breakage or damage on pipes. Check joints for fluid leakage. If any cracks, breakage, damage or fluid leakage is found, repair or replace the pipes.
NOTE: Use a mirror when inspecting the low-visible part or backside.