Pressure Plate

Install the clutch cover to the flywheel and tighten the bolts to the specified torque.

NOTE:
^ When installing the clutch cover to the flywheel, position the clutch cover in order to make the gap between imbalance marks (0 paint mark) of flywheel and clutch cover 120° or more. (The imbalance marks show the residual imbalance direction.)
^ Note the front and rear of the clutch disc when installing.
^ Tighten the clutch cover installing bolts gradually. Each bolt should be tightened to the specified torque in a crisscross order.

Tightening torque: 16 Nm (1.6 kgf-m, 11.6 ft. lbs.)