on the Subaru Select Monitor, select the {2. Check individual system} -> {Keyless unit mode} -> {1. Keyless ID registration}, and press the [YES] key.
4. Input the 8-digit ID number from the left attached to the plastic bag of transmitter or circuit board inside transmitter.

NOTE: Press the [/\] key on the Subaru Select Monitor to increase the number, and the [\/] key to decrease. Press the [<] key to move to the digit in the left, and [>] to the right.

5. The ID number you have entered will be shown. Make sure that the ID number shown is the same as that of plastic bag.
6. Press the [YES] key if the ID number is correct. Press the [NO] key if incorrect, to return to the step 3) and try again.
7. will be displayed and registration started.
8. will be shown when the process is done.
9. To end, select the , and press the [NO] key to return to {1. Keyless ID registration}. If there are additional transmitters to be registered, select the , and press the [YES] key to return to the step 3).

NOTE:
- If the registration fails, will be shown. Press the [YES] key to return to the {1. Keyless ID registration} and retry from the step 2).
- is shown on the Subaru Select Monitor when four transmitters have been registered. Press the [NO] key to return to {1. Keyless ID registration}.