Front Crossmember Support Plate

Front Crossmember Support Plate

REMOVAL
1. Lift up the vehicle.
2. Remove the front under cover.
3. Remove the bolt and remove front crossmember support plate.

^ Large type





^ Small type





INSTALLATION
Install in the reverse order of removal.

NOTE: Tighten the small type crossmember support plate together with stabilizer bracket. After installing the stabilizer bracket to the crossmember, tighten the crossmember support plate together.

Tightening torque:
Crossmember support plate: 60 Nm (6.1 kgf-m, 44.3 ft. lbs.)
Crossmember support plate (Tightened together with the stabilizer bracket): 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
Jack-up plate: 60 Nm (6.1 kgf-m, 44.3 ft. lbs.)