Front

REMOVAL
15-INCH TYPE
1. Lift-up the vehicle, and remove the front wheels.





2. Remove the caliper body and the support from housing, and suspend it from strut using a wire.





3. Remove the disc rotor.

NOTE: If the disc rotor seizes up within hub, drive the disc rotor out by pushing with an 8 mm bolt in holes B on the rotor.

4. Clean mud and foreign particles from the caliper body assembly and the support.

16-INCH TYPE
Refer to 15-inch type.

17-INCH TYPE
Refer to 15-inch type.

INSTALLATION
1. Install the disc rotor.
2. Install the caliper body and the support to housing.
Tightening torque: 80 Nm (8.2 kgf-m, 59 ft. lbs.)
3. Install the front wheels.