Tail Lamp: Service and Repair

Rear Combination Light Assembly

REMOVAL
1. SEDAN MODEL
1. Disconnect the ground cable from battery.
2. Remove the trunk room side trim.




3. Remove the four nuts, and then detach the rear combination light after disconnecting the connector.

2. WAGON MODEL
1. Disconnect the ground cable from battery.




2. Remove the clips.




3. While pressing the portion (A), insert your finger or flat-tip screwdriver wrapped with tape into the clearance (B) to remove pawls in the order of (C), (D), (E), and remove the rear combination cover.




4. Remove the two bolts, and then detach the rear combination light by pulling it to the rear side of vehicle.
5. Remove the rear combination light after turning the socket of tail/stop light bulb and rear turn signal light bulb to remove the bulbs.

INSTALLATION
Install in the reverse order of removal.