Evaporator Case: Service and Repair
EvaporatorREMOVAL
1. Disconnect the refrigerant recovery & toe board area A/C pipe.
2. Remove the glove box.
3. Remove lower motor unit assembly.
4. Loosen the screws and remove evaporator cover.
5. Remove the A/C pipes in unit.
6. Rotate the upper evaporator core and lower evaporator core tilt toward the front vehicle and toward the interior, respectively. Then pull out the heater case to left side.
7. Loosen the two bolts to remove expansion valve.
CAUTION: If the evaporator is replaced, add appropriate amount of compressor oil to evaporator.
INSTALLATION
Install in the reverse order of removal.
NOTE: Replace the O-ring for refrigerant recovery & toe board area air conditioner pipe with a new one, and then apply compressor oil.