Reduction Driven Gear

Reduction Driven Gear

REMOVAL
1. Remove the transmission assembly from vehicle.
2. Remove the rear vehicle speed sensor, and then separate the extension case from transmission case.
3. Set the select lever to P range.





4. Remove the caulking part, and then remove the lock nut.





5. Using the ST1 and ST2, extract the reduction driven gear.
ST1 499737000 PULLER
ST2 899524100 PULLER SET

INSTALLATION
1. Set the select lever to P range.





2. Using a plastic hammer, install the reduction driven gear assembly and new washer, and tighten new drive pinion lock nut.
Tightening torque: 100 Nm (10.2 kgf-cm, 73.8 ft. lbs.)
3. After tightening, stake the lock nut securely.
4. Combine the transmission case with extension case, and then install the rear vehicle speed sensor.
5. Install the transmission assembly into vehicle.

DISASSEMBLY





1. Remove the snap ring from reduction driven gear.





2. Remove the ball bearing from reduction driven gear using ST.
ST 498077600 REMOVER
3. Remove the snap ring from reduction driven gear.

ASSEMBLY
1. Install the snap ring to reduction driven gear.





2. Install the new ball bearing to reduction driven gear using press.





3. Install the snap ring to reduction driven gear.

INSPECTION
Make sure the ball bearing and gear is not deformed or damaged.