Installation

INSTALLATION

1) Install the ATF inlet pipe and outlet pipe along with new washers.

Tightening torque:
T1: 25 N-m (2.5 kgf-m, 18.4 ft-lb)
T2: 40 N-m (4.1 kgf-m, 29.5 ft-lb)
T3: 45 N-m (4.6 kgf-m, 33.2 ft-lb)





2) Install the ATF cooler pipe to frame.





3) Connect the ATF cooler hose to the pipe on the transmission side.

NOTE:
^ Install so that the hose is not folded over, excessively bent or twisted.
^ Insert the hose to the specified position.





4) Connect the ATF cooler hose to the pipe on the radiator side.

NOTE:
^ Install so that the hose is not folded over, excessively bent or twisted.
^ Insert the hose to the specified position.





5) Install the heat shield cover.

Tightening torque: 3 N-m (0.3 kgf-m, 2.2 ft-lb)





6) Install the under cover.
7) Install the battery.
8) Fill ATF.

NOTE:
Make sure there are no ATF leaks in joints between the transmission, radiator, pipes, and hoses.