Valve Clearance: Adjustments

ADJUSTMENT

NOTE: Adjustment of valve clearance should be performed while engine is cold.

1. Measure all the valve clearances.

NOTE: Record each valve clearance after measurement.





2. Remove the camshaft.
3. Remove the valve lifter.
4. Measure the thickness of valve lifter using micrometer.





5. Select a valve lifter of suitable thickness from the following table using the measured valve clearance and valve lifter thickness, and install it.

NOTE: Use a new valve lifter.











6. Install the camshaft.
7. Install the cam sprocket.
8. Install the timing belt.
9. Measure all valves for valve clearance again at this time. If the valve clearance is not correct, repeat the procedure over again from the first step.
10. After measuring, install the related parts in the reverse order of removal.

NOTE:
^ Use a new rocker cover gasket.
^ Use a new clamp for the PCV hose clamp, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

ST 18353AA000 CLAMP PLIERS