Rear Door Window Glass: Service and Repair

REAR DOOR GLASS

Rear Door Glass:

REMOVAL
1. Remove the rear door trim.
2. Remove the sealing cover.
3. Remove the stabilizers.







4. Remove clips (A), and remove the front end and rear end of the weather strip.







5. Remove the two screws to remove the weather strip outer.







6. Connect the ground cable to battery and power window switch connector.
7. Operate the power window switch to move the glass to the position shown in the figure, then remove the two nuts through the service holes.







8. Remove the rear sash retaining nuts (A) and move the rear sash (B) rearward.







9. Remove the door glass.

CAUTION:
- Since the gear may be disengaged, do not turn regulator in the closing direction after removing glass.
- Avoid impact and damage to the glass.

INSTALLATION

1. Install in the reverse order of removal.

CAUTION: Make sure that the glass stay is placed securely in sash.

2. Adjust the rear door glass.

Tightening torque: Refer to "COMPONENT" of "General Description". [Ref. to REAR DOOR GLASS, COMPONENT, General Description.]