Keyless Entry Receiver: Service and Repair

Keyless Entry Control Module

REMOVAL

1. SEDAN MODEL
1. Disconnect the ground cable from battery.
2. Remove the rear shelf trim.
3. Remove the keyless entry control module.
1. Disconnect the connector.
2. Remove the bolt and remove the keyless entry control module.






2. OUTBACK MODEL
1. Disconnect the ground cable from battery.
2. Remove the rear quarter trim LH.
3. Remove the keyless entry control module.
1. Disconnect the connector.
2. Remove the bolt and remove the keyless entry control module.






INSTALLATION

Install each part in the reverse order of removal.

Tightening torque:
Keyless entry control module: 13 N.m (1.33 kgf.m, 9.6 ft.lb)