Rear Combination Light Assembly
Rear Combination Light AssemblyREMOVAL
1. 4 DOOR MODEL
1. Disconnect the ground cable from battery.
2. Remove the trunk room side trim.
3. Remove the harness connector and nuts, and detach the rear combination light.
2. 5 DOOR MODEL
1. Disconnect the ground cable from battery.
2. Remove the bolts, and then detach the rear combination light by pulling it to the rear side of vehicle.
3. Disconnect the harness connector and remove the rear combination light.
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)