Fuel Injector: Service and Repair
Fuel InjectorREMOVAL
1. RH SIDE
1. Release the fuel pressure.
2. Disconnect the ground cable from battery.
3. Open the fuel filler lid and remove the fuel filler cap.
4. Remove the intake boot.
5. Remove the spark plug cords from spark plugs (#1 and #3 cylinders).
6. Remove the fuel pipe protector RH.
7. Remove the harness band (B) which holds the engine harness to the fuel injector pipe, and disconnect the connectors (A) from fuel injector.
8. Remove the bolts which hold fuel injector pipe onto intake manifold.
9. Remove the fuel injector while lifting up the fuel injector pipe.
2. LH SIDE
1. Release the fuel pressure.
2. Remove the battery.
3. Open the fuel filler lid and remove the fuel filler cap.
4. Remove the spark plug cords from spark plugs (#2 and #4 cylinders).
5. Remove the fuel pipe protector LH.
6. Remove the harness band (B) which holds the engine harness to the fuel injector pipe, and disconnect the connectors (A) from fuel injector.
7. Remove the bolts which hold fuel injector pipe onto intake manifold.
8. Remove the fuel injector while lifting up the fuel injector pipe.
INSTALLATION
1. RH SIDE
Install in the reverse order of removal.
NOTE: Use new O-rings.
Tightening torque: 19 N.m (1.9 kgf.m, 14.0 ft.lb)
Tightening torque: 19 N.m (1.9 kgf.m, 14.0 ft.lb)
2. LH SIDE
Install in the reverse order of removal.
NOTE: Use new O-rings.
Tightening torque: 6.4 N.m (0.7 kgf.m, 4.7 ft.lb)
Tightening torque: 19 N.m (1.9 kgf.m, 14.0 ft.lb)
Tightening torque: 19 N.m (1.9 kgf.m, 14.0 ft.lb)
