A/T Fluid Replacement
Automatic Transmission FluidREPLACEMENT
1) Lift up the vehicle.
2) Remove the ATF drain plug to drain ATF.
CAUTION:
^ Be careful not to spill differential gear oil on the exhaust pipe to prevent it from emitting smoke or causing a fire. If differential gear oil is spilled on the exhaust pipe, wipe it off completely.
^ Directly after the vehicle has been running or the engine has been long idle running, the ATF is hot. Be careful not to burn yourself.
3) Check the ATF condition. A/T Fluid Condition Check
4) Tighten the ATF drain plug.
NOTE:
Use a new gasket.
Tightening torque:
20 Nm (2.0 kgf-m, 14.8 ft-lb)
5) Lower the vehicle.
6) Pour ATF from the oil charge pipe.
Specified fluid:
SUBARU ATF
Recommended fluid:
IDEMITSU ATF HP
NOTE:
Use of the recommended fluid is permitted only in regions where the specified fluid is not available.
Capacity:
Fill with the same amount of ATF as drained.
Capacity when transmission is overhauled:
9.6 - 10.0 l (10.1 - 10.6 US qt, 8.4 - 8.8 Imp qt)
7) Check the level and leaks of ATF. A/T Fluid Inspection