Removal and Replacement

Brake Pedal

REMOVAL

MT MODEL

1) Remove the steering column.
2) Disconnect the connector from clutch switch.
3) Disconnect the connector from stop light switch.
4) Remove the clevis pin which secures the pedal and operating rod.





5) Remove the nut which secures the clutch master cylinder.
6) Remove the bolt and nut which secures the pedal bracket.





AT MODEL

1) Remove the steering column.
2) Disconnect the connector from stop light switch.
3) Remove the clevis pin which secures the brake pedal and operating rod.





4) Remove the bolts and nuts which secure the brake pedal bracket.





INSTALLATION

1) Install the bolt and nut which secure the brake pedal bracket.

Tightening torque:
18 Nm (1.84 kgf-m, 13.3 ft-lb)

2) Install clevis pin and snap pin which secure the operating rod to the brake pedal.

NOTE:
^ Replace with a new clevis pin.
^ Apply NIGTIGHT LYW No. 2 grease to the clevis pin.





3) Connect the stop light switch connector.
4) Check that the brake light operate properly.
5) Check the brake pedal after installation. Overhaul